FS - Sparco Rev seat (one) with sliders and brackets (NEW)

[D Algozine]

One new Sparco Rev seats with sliders and brackets

 

Installed but never used. New condition - 2008 date code

 

Seat with sliders and steel brackets $ 500 plus shipping

 

Only one seat left

 

[email protected]

 

 

 

Edited October 26, 2010 by Guest

[bukit]

What size are they? I'm 5'10', 175 lbs with a 34 inch waist. Think they'll fit me?

[D Algozine]

What size are they? I'm 5'10', 175 lbs with a 34 inch waist. Think they'll fit me?

 

 

Here's a chart with dimensions http://www.bakerprecision.com/seatsize.htm

 

I'm 6' , 210lbs with a 34 in waist and the Rev is too tight for me.

Edited June 1, 2010 by Guest

[bukit]

What type of car did you install them in?

[D Algozine]

What type of car did you install them in?

 

They were in a 94 Mustang for a test fit, but it doesn't matter. You will need to by the car specific bracket from Sparco. This bracket attaches to the floor and then to the sliders. Unless you perform a custom install.

[D Algozine]

Seats still avialable !!

[Steve_ap1]

Seats still avialable !!

 

how much do you want for just one seat, without rails and sliders to 27519?

[D Algozine]

Seats still avialable !!

 

how much do you want for just one seat, without rails and sliders to 27519?

 

Sorry for the delay. The seat cost $750 plus shipping. I'd go $500 shipped.

[_matt_]

Hi, is the other seat still available?

 

Thanks!

[D Algozine]

Hi, is the other seat still available?

 

Thanks!

 

Both seats have been sold.

 

Aslo, I will need to check to see if I have any sliders left.