Hampton Posted November 14, 2010 Share Posted November 14, 2010 (edited) Puchased brand new, installed, then rolled the car on and off a trailer one time FR Upright / spindle: $75 Hawk DTC-30 Pads: $100 Shipped to anywhere in the US Tie Rod Ends (both): $25 each Brand new / never installed: Longacre Aluminum 13 inch Racing Steering Wheel (low dish and fat rubber grip): $60 Shipped tpo anywhere in the US Front bumper with all accessories, brackets and Air Guid (ready to install): $300 1.6 Coil pack: $110 Shipped to anywhere in the US Used: FR Fender (red, no rust and only a couple small dents): $75 each Hood (aluminum / red, perfect condition): $150 Trunk Lid (red - has a few dents): $50 Can ship the larger body parts very cheap via Greyhouse PackageExpress Used Engine (180K, ran fine before I pulled it): ? Sold: Hawk DTC-60 Pads:Sold MSD Ignition Wire Set: Sold 1.6 Gasket and hose set / kit: Sold Water pump: Sold Timing belt: Sold Front upper CA's:Sold Front Hub's:Sold Shocks & Springs from the Spec Miata Suspension Kit: Sold Quick release SPLINE steering wheel adaptor: Sold Rear spindles with hubs/bearingsSold Koyo 53 mm Aluminum Racing Radiator: Sold Oil Pressure Sender Relocation Unit:Sold Stainless steel brake lines (front & rear with all hardware): Sold Front and Rear Sway Bars from SM Suspension Kit (with brackets and hardware): Sold Adjustable end links: Sold Set (4) Team Dynamics Pro 2.0 / Offset:30mm / Color: Anthracite:Sold Front lower CA's:Sold Front Calipers:Sold Rear upper CA's:Sold Rear lower CA's:Sold Rear Calipers with brackets and hardware(2 rear lefts & 2 rear rights):Sold Used Coil pack (brand new coil pack still available):Sold Transmission:Sold Toyo R888's full tread:Sold RF Fender: Sold Front Cross Member:Sold Rear subframe:Sold Hard Top:Sold Located in Des Moines IA PM me for pictures and/or further discussion. Thanks Greg Edited February 7, 2011 by Guest Quote Link to comment Share on other sites More sharing options...
Hampton Posted November 20, 2010 Author Share Posted November 20, 2010 Updated Quote Link to comment Share on other sites More sharing options...
Hampton Posted February 4, 2011 Author Share Posted February 4, 2011 Updated Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.