1989 Camaro RS Roller and LT1/T56, 3.42 rear w/ disc brake +

[APatelIroc]

Hey all, unfortunately i have to get out of racing before i can even get into it... i am putting everything i have (for a CMC build) up for sale.

 

I have a 1989 Camaro RS roller in excellent condition with basically no rust anywhere. Its white, with a red 1992 z28 hood. Few areas have been sanded and primed. Interior is red and has 4th gen dash but also comes with the original 3rd gen dash. It has a cutout in the floor for a manual conversion. I have to check again if it has the peddles for manual or not (i have had it covered for a long time). Interior is probably 80-90% complete but had already started to remove most things for CMC build.

 

this was going to by my CMC build but i am no longer getting into racing so I am selling what i have.

 

Looking for $600 OBO.

 

 

I also have a 1993 LT1/T56, driveshaft, 3.42 gear disc brake rear end and gas tank w/ new fuel pump all from a 1993 Formula It only has 26k miles on it and i saw it run before it was pulled from the car. Runs excellent but sounds like there is an exhaust leak from passenger manifold. Motor is 99% complete. previous owner pulled it and sold it because barn door fell on car on destroyed most of the body.

 

Looking for $1800 for entire drivetrain. comes with PCM and entire engine harness with T56 connectors.

 

NEW Hawks Thirdgen T-56 swap cross member (No safety loop) - $80 + shipping.

 

Roller, LT1/T56, driveshaft, rear end, gas tank, and t-56 swap cross member all for $2,200.

 

This is a PERFECT combination to get into CMC or for spare parts for your current car.

 

Please send me your email and I'll send pics. I am located in Bellmore, Long Island, NY. Also please allow me a couple days to get back to you due to the power outages we have for a few days. I may get back right away or i may not depending on internet access.

 

Prefer pick up only unless you somehow arrange for shipping these things.

 

Thanks!