Jump to content

PROPOSED RULE 2015: Change dyno variance to a percentage


JSG1901

Recommended Posts

Proposed change

Change from a a fixed dyno variance to a percentage based difference.

 

Reason

The error in a dyno due to calibration, etc. is unlikely to be a fixed number across the entire range of measurement. If the weight of the drum, friction factors, load cell calibration, etc are off, the calculations done by the dyno software will multiplicative in error not additive. By changing to a percentage of error, it should be more accurate to the actual variance experienced by the range of cars.

 

Looking at the typical HP ranges for GTS1 through GTS5 cars, a 4 hp variance is as much as 2.5% and as little as 0.9% of a declared number. With the fixed 4 hp, drivers at the lower RPM ranges might be incented to push the limit whereas a driver with a high HP car needs to have a larger cushion.

 

Proposed wording

To allow a small safety margin for dyno variance, the peak HP number (or average of peak HP/TQ for those cars it applies to) will be multiplied by 0.98 (number up for discussion). However, if a car does not meet the minimum weight listed on the certification sheet, the forgiveness cannot be used to arrive at a compliant number.

Link to post
Share on other sites

Yes, that makes perfect sense.

 

We should do the same with the various power-to-weight penalties as well. Penalizing a sequential tranny with 0.2 lbs/hp is a 1% penalty in GTS1 and a 2.7% penalty in GTS5, which doesn't make sense. It too should be a percentage.

Link to post
Share on other sites

Yes. This make sense!

And I think using the .98 as the factor is pretty darn close, but I may like .985 better to keep things a little tighter.

Link to post
Share on other sites
CARVAL Motorsports

Is this correct:

 

declared

100hp - 102 good on dyno

200hp - 204 good

300hp - 306 good

400hp - 408 good

500hp - 510 good

 

I fear that the lower hp cars could fail at the dyno disproportionately to the higher hp cars. Food for thought.

Link to post
Share on other sites
Guest
This topic is now closed to further replies.
×
×
  • Create New...