Jump to content
imissedtheapex

Holes in floorboard from moving harness mounts-OK for HPDE??

Recommended Posts

imissedtheapex

question for yall - I had to remount my harnesses because I have a new seat. So I ended up with a number of holes in the floor board. Will this still pass tech for HPDE? For fire protection I was thinking of JB Welding some steel plates over the holes...or do I have to actually weld them over? Another thought was making sandwich plates and bolting them together. Any input would be appreciated... Buttonwillow is in one week!

Share this post


Link to post
Share on other sites
ILIKETODRIVE

I use 3M foil tape (doubled-up over itself) to cover up old ballast bolt holes and various other small/insignificant factory holes.

Share this post


Link to post
Share on other sites
n80

I use the same sized bolt with a big washer and nut. Put a little caulk or gasket maker on the contact surface of the washer to keep water out.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×